价格:¥0.00/件
品牌:Powernet
发货:3天内
POWERNET 电源MSR 4800W
4800 W 模块化系统
每个模块的所有可用电压为 0…144VDC
U 和 I 从 0 到最大值可调 热插拔插件模块
电源或电池充电应用 用于远程监控的模块警报
适用于重型应用的坚固结构
POWERNET 电源MSR 4800w 系列
19” SUB-RACK UNITS | |||
Type | Modules per rack | Power | Mechanics (w x h x d) |
MSR7650 | 1…6 pcs | 800W…4800W | 19” (482mm) / 3U (133Mm) / 330mm (+handle 40mm) |
8876500C | Covering plate set for empty module place | ||
70130753 | IEC320 power cord 2.5m, rubber cable |
RECTIFIER MODULES | |||||||
Type | Input voltage *) | Nominal Output Voltage | Voltage Setting Range | Max Output Current | Current Limit Setting | Max Power | Mechanics (w x h x d) |
ADC7181R/24 | 55-264VAC/78-360VDC | 24 VDC | 0-36VDC | 30 A | 0-30A | 800W | 14TE / 3U / 230mm |
ADC7181R/36 | 55-264VAC/78-360VDC | 36 VDC | 0-54VDC | 20 A | 0-20A | 800W | 14TE / 3U / 230mm |
ADC7181R/48 | 55-264VAC/78-360VDC | 48 VDC | 0-72VDC | 15 A | 0-15A | 800W | 14TE / 3U / 230mm |
ADC7181R/72 | 55-264VAC/78-360VDC | 72 VDC | 0-108VDC | 10 A | 0-10A | 800W | 14TE / 3U / 230mm |
ADC7181R/96 | 55-264VAC/78-360VDC | 96 VDC | 0-144VDC | 7.5A | 0-7.5A | 800W | 14TE / 3U / 230mm |
*) Max power 600W at DC input
Reduced power 55…200VAC or 78…200VDC
INPUT | ||
Input voltage | 55…264 VAC | 55…200VAC reduced power, see module datasheet |
78…360 VDC / max 600W | 78…200VDC reduced power, see module datasheet | |
Frequency | 45...65Hz | |
Input current | Max 4.5A per module | |
Inrush current | Soft start | max 7A 10ms peak, otherwise less than 4.5A |
Safety | According to EN60950, Class I | |
Isolation | Input / ground | 1500VAC |
Input / outputs | 3750VAC | |
Output / ground | 500VDC | |
Mains input connector | Common input 1 for unit 1, 2 and 3 | IEC320 C14 male connector |
Common input 2 for unit 4, 5 and 6 | ||
Located on rear panel | (L-N-PE) |
OUTPUT
Voltage Nominal voltages 0…144VDC / max 800W per module Current Nominal current per module 0…30A / max 800W per module Short circuit protection The modules are short circuit protected
Output connector 6 x poSITIve and 6 x negative output group 10mm2 screw terminal for each rectifier
short-circuit contact for parallel operation Hot swap Serial diode in each rectifier Hot-swap allowed
Serial/parallel operations All modules can be connected in series or in parallel
ALARMS
Output failure | Module failure | Relay contact |
Alarm connector | Rear panel | Removable 12-pole 2.5mm2 screw terminal |
Pin configurations |
1 Output alarm PSU1 COMMON
2 Output alarm PSU1 NO *)
3 Output alarm PSU2 COMMON
4 Output alarm PSU2 NO *)
5 Output alarm PSU3 COMMON
6 Output alarm PSU3 NO *)
7 Output alarm PSU4 COMMON
8 Output alarm PSU4 NO *)
9 Output alarm PSU5 COMMON
10 Output alarm PSU5 NO *)
11 Output alarm PSU6 COMMON
12 Output alarm PSU6 NO *)
*) NO = Normally Open Normally = Mains / PSU OK
NC contacts also available, type MSR7651
MECHANICAL
Power Rack Dimensions | 19” sub-rack Height | Positions for 6 pcs of ADC7181 euro modules 3U (88mm) |
Width | 19” (482mm) | |
Depth | 330mm (+ handle 40mm) | |
Weight | Rack without rectifiers | 4.0 kg |
Rectifier | 1.35kg/unit | |
Enclosure | Steel | IP20 |
ENVIRONMENTAL
Temperature range | Operating | -25°C...+50 °C (full power typically) |
+50°C...+70 °C (de-rating) | ||
Storage | -40°C...+85 °C | |
Cooling | Temperature controlled fan | Front panel, air flow front to rear |
Grounding | M6 screw | On the rear panel |